Dell Force10 Z9000 - 42 Rapid Spanning Tree Protocol (RSTP); Bridge-Priority

42
Rapid Spanning Tree Protocol (RSTP)
The Dell Force10 operating software (FTOS) implementation of rapid spanning tree protocol (RSTP) is based on the IEEE
802.1w standard spanning-tree protocol. The RSTP algorithm configures connectivity throughout a bridged local area
network (LAN) that is comprised of LANs interconnected by bridges.
RSTP is supported by FTOS on the C-Series, E-Series, S-Series, Z-Series, or S4810 platforms.
bridge-priority
Set the bridge priority for RSTP.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
bridge-priority priority-value
To return to the default value, use the no bridge-priority command.
Parameters
priority-value Enter a number as the bridge priority value in increments of 4096. The
range is 0 to 61440. The default is 32768.
Defaults 32768
Command Modes CONFIGURATION RSTP (conf-rstp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Related
Commands
protocol spanning-tree rstp – enters rapid spanning tree mode.
1273