Dell Force10 Z9000 Reference Guide

Defaults zero (0) seconds.
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
ip ospf authentication-key
Enable authentication and set an authentication key on OSPF traffic on an interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip ospf authentication-key [encryption-type] key
To delete an authentication key, use the no ip ospf authentication-key command.
Parameters
encryption-type (OPTIONAL) Enter 7 to encrypt the key.
key Enter an eight-character string. Strings longer than eight characters
are truncated.
Defaults Not configured.
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
All neighboring routers in the same network must use the same password to exchange OSPF
information.
ip ospf cost
Change the cost associated with the OSPF traffic on an interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip ospf cost cost
1055

Dell Force10 Z9000 Specifications

General

Switching Capacity	2.56 Tbps
Power Supply	Dual, hot-swappable
MTBF	200, 000 hours
Ports	32 x 40GbE QSFP+
Cooling	Front-to-back airflow
Form Factor	Fixed
Jumbo Frame Support	Up to 9216 bytes
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
MAC Address Table Size	128K
Dimensions (HxWxD)	3.45 in x 17.32 in x 20.0 in