Dell Force10 Z9000 - Network; Neighbor Route-Reflector-Client

Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of
the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in
the Route map used in this command. If you identify a peer by IP address, the Route map
overwrites either the inbound or outbound policies on that peer.
neighbor route-reflector-client
Configure a neighbor as a member of a route reflector cluster.
C-Series, E-Series TeraScale, S-Series
Syntax
neighbor {ip-address | peer-group-name} route-reflector-client
To indicate that the neighbor is not a route reflector client or to delete a route reflector
configuration, use the no neighbor ip-address | peer-group-name route-
reflector-client
command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
All routers in the peer group receive routes from a route reflector.
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
The first time you enter this command, it configures the neighbor as a route reflector and
members of the route-reflector cluster. If you configure a route reflector, internal BGP (IBGP)
speakers do not need to be fully meshed.
When you disable all clients of a route reflector, the neighbor is no longer a route reflector.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
C-Series, E-Series TeraScale, S-Series
Syntax
network ip-address mask [route-map map-name]
430