Dell Force10 Z9000 - Duplex (10;100 Interfaces)

Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Documentation modified—added Management to distinguish from
duplex (10/100 Interfaces).
Usage
Information
This command applies only to the Management interface on the route processor modules
(RPMs).
Related
Commands
interface ManagementEthernet – configures the Management port on the system (either the
Primary or Standby RPM).
duplex (Management) – sets the mode of the Management interface.
management route – configures a static route that points to the Management interface or a
forwarding router.
speed (Management interface) – sets the speed on the Management interface.
duplex (10/100 Interfaces)
Configure duplex mode on any physical interfaces where the speed is set to 10/100.
C-Series, E-Series. S-Series, Z-Series, S4810
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half Enter the keyword half to set the physical interface to transmit only
in one direction.
full Enter the keyword full to set the physical interface to transmit in
both directions.
Defaults Not configured.
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.4.1.0 Introduced
694