Dell Force10 Z9000 - Clear Host; Clear Ip Fib Linecard

pre-Version
6.2.1.1
Introduced on the E-Series.
clear host
Remove one or all dynamically learned host table entries.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
clear host name
Parameters
name Enter the name of the host to delete. Enter * to delete all host table
entries.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
clear ip fib linecard
Clear all forwarding information base (fib) entries in the specified line card (use this command with caution, refer to
Usage Information below).
C-Series, E-Series
Syntax
clear ip fib linecard slot-number | vrf vrf instance
Parameters
slot-number Enter the number of the line card slot. The range is 0 to 7.
vrf instance (Optional) E-Series Only: Clear only the FIB entries on the specified
card associated with the VRF instance.
Command Modes
• EXEC
• EXEC Privilege
774