Dell Force10 Z9000 - Show Ip Bgp Paths

show ip bgp paths
View all the BGP path attributes in the BGP database.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip bgp paths [regexp regular-expression]
Parameters
regexp regular-
expression
Enter a regular expression then use one or a combination of the
following characters to match:
• . = (period) any single character (including a white space).
• * = (asterisk) the sequences in a pattern (0 or more
sequences).
• + = (plus) the sequences in a pattern (1 or more sequences).
• ? = (question mark) sequences in a pattern (either 0 or 1
sequences).
NOTE: You must enter an escape sequence (CTRL+v) prior
to entering the ? regular expression.
• [ ] = (brackets) a range of single-character patterns.
• ( ) = (parenthesis) groups a series of pattern elements to a
single element.
• { } = (braces) minimum and the maximum match count.
• ^ = (caret) the beginning of the input string. If you use the
caret at the beginning of a sequence or range, it matches on
everything BUT the characters specified.
• $ = (dollar sign) the end of the output string.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp path command shown in the Example below.
Field Description
Total Displays the total number of BGP path attributes.
Address Displays the internal address where the path attribute is stored.
Hash Displays the hash bucket where the path attribute is stored.
407