Dell Force10 Z9000 - Load-Balance Hg

• IP source address
• IP destination address
• IP Protocol type
• TCP/UDP source port
• TCP/UDP destination port
NOTE: For IPV6, only the first 32 bits (LSB) of IP Source Address and IP Destination
Address are used for hash generation.
The table below lists the load balance command options and how the command
combinations affect the distribution of traffic.
Configuration Switched IP Traffic Routed IP Traffic
(IPV4 Only)
Switched Non-IP
Traffic
Default (IP 5-tuple) IP 5-tuple IP 5-tuple MAC based
ip-selection 3-tuple IP 3-tuple IP 3-tuple MAC based
mac MAC based IP 5-tuple MAC based
ip-selection 3-tuple
and mac
MAC based IP 3-tuple MAC based
ip-selection packet-
based
Packet based: IPV4
No distribution: IPV6
Packet based: IPV4 MAC based
ip-selection packet-
based and mac
MAC based Packet based: IPV4 MAC based
Related
Commands
ip address – change the algorithm used to distribute traffic on an E-Series chassis.
load-balance hg
Choose the traffic flow parameters to be used in the hash calculation while distributing the traffic across internal higig
links.
Z-Series
Syntax
[no] load-balance hg { ip-selection | ipv6-selection [source-ip
| source-ipv6 | source-port-id | source-module-id | dest-ip |
dest-ipv6 | dest-port-id | dest-module-id | protocol | vlan |
L4-source-port | L4-dest-port ] | mac [source-mac | source-
port-id | source-module-id | dest-mac | dest-port-id | dest-
module-id | vlan | ethertype | source-dest-mac ] | tunnel
[ipv4-over-ipv4 | ipv4-over-gre-ipv4 | mac-in-mac]}
800