Dell Force10 Z9000 - Page 801

Parameters
{ip-selection|
ipv6-selection
[ source-ip |
source-ipv6 |
source-port-id |
source-module-id
| dest-ip | dest-
ipv6 | dest-port-id
| dest-module-id |
protocol | vlan |
L4-source-port |
L4-dest-port ]
To use IPv4 key fields in hash computation, enter the keyword
ip-
selection
followed by one of the parameters. To use IPv6 key
fields in hash computation, enter the keyword ipv6-selection
followed by one of the parameters.
• source-ip—Use IPv4 src-ip field in hash calculation.
• source-ipv6—Use IPv6 src-ip field in hash calculation
• source-port-id—Use src-port-id field in hash calculation.
• source-module-id—Use src-module-id field in hash
calculation.
• dest-ip—Use IPv4 dest-ip field in hash calculation.
• dest-ipv6—Use IPv6 dest-ip field in hash calculation
• dest-port-id—Use dest-port-id field in hash calculation.
• dest-module-id—Use dest-module-id field in hash
calculation.
• protocol—Use IPv4 protocol field in hash calculation.
• vlan—Use vlan field in hash calculation.
• L4-source-port—Use IPv4 L4-source-port field in hash
calculation.
• L4-dest-port—Use IPv4 L4-dest-port field in hash calculation.
mac [ source-mac
| source-port-id |
source-module-id
| dest-mac | dest-
port-id | dest-
module-id | vlan |
ethertype |
source-dest-
mac ]
To use MAC key fields in hash computation, enter the keyword mac
followed by one of the parameters:
• source-mac—Use source-mac field in hash calculation.
• source-port-id—Use src-port-id field in hash calculation.
• source-module-id—Use src-module-id field in hash
calculation.
• dest-mac—Use dest-mac field in hash calculation.
• dest-port-id—Use dest-port-id field in hash calculation.
• dest-module-id—Use dest-module-id field in hash
calculation.
• vlan—Use vlan field in hash calculation .
• ethertype—Use Ethertype field in hash calculation.
• source-dest-mac—Use SMAC and DMAC fields in hash
calculation.
tunnel [ ipv4-over-
ipv4 | ipv4-over-
gre-ipv4 | mac-in-
mac ]}
To use tunnel key fields in hash computation, enter the keyword
tunnel followed by one of the parameters:
• ipv4-over-ipv4—Use ipv4-over-ipv4 field in hash calculation.
• ipv4-over-gre-ipv4—Use ipv4-over-gre-ipv4 field in hash
calculation.
• mac-in-mac—Use mac-in-mac field in hash calculation.
Defaults IP selection 5-tuples (source-ip dest-ip vlan protocol L4-source-port L4-dest-port).
Command Modes CONFIGURATION
801