Dell Force10 Z9000 - Match Ip Precedence

Related
Commands
class-map – identifies the class map.
match ip precedence
Use IP precedence values as a match criteria.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
match ip precedence ip-precedence-list [[multicast] set-ip-dscp
value]
To remove IP precedence as a match criteria, use the no match ip precedence ip-
precedence-list [[multicast] set-ip-dscp value] command.
Parameters
ip-precedence-
list
Enter the IP precedence value(s) as the match criteria. Separate
values by commas — no spaces ( 1,2,3 ) or indicate a list of values
separated by a hyphen (1-3). The range is 0 to 7.
multicast (OPTIONAL) Enter the keyword multicast to match against
multicast traffic.
NOTE: This option is not supported on the C-Series or S-Series.
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp followed by the IP
DSCP value. The matched traffic is marked with the DSCP value. The
range is 0 to 63.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Added the keyword multicast. Added support for the DSCP
marking
option for the S-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.5.1.0 Added support for the DSCP Marking option.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
You must enter the class-map command in order to access this command. After the class
map is identified, you can configure the match criteria.
1198