Dell Force10 Z9000 - 26 Link Aggregation Control Protocol (LACP); Clear Lacp Counters

26
Link Aggregation Control Protocol (LACP)
This chapter contains commands for Dell Force10’s implementation of the link aggregation control protocol (LACP) for
creating dynamic link aggregation groups (LAGs)—known as “port-channels” in the Dell Force10 operating software
[FTOS]. The LACP commands in this chapter are supported by FTOS on all E-Series, C-Series, S-Series, Z-Series, or
S4810 Dell Force10 systems.
NOTE: For static LAG commands, refer to Port Channel Commands in the Interfaces chapter), based on the
standards specified in the IEEE 802.3 Carrier sense multiple access with collision detection (CSMA/CD) access
method and physical layer specifications.
NOTE: An FTOS option provides hitless dynamic LACP states (no noticeable impact to dynamic LACP states after an
route processor module [RPM] failover) on the E-Series. For more information, refer to the Redundancy Protocol in
the High Availability
chapter.
clear lacp counters
Clear Port Channel counters.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
clear lacp port-channel-number counters
Parameters
port-channel-
number
Enter a port-channel number: For the C-Series and S-Series, the
range is 1 to 128. For the E-Series, the range is 1 to 255 for TeraScale
and 1 to 512 for ExaScale.
Defaults Without a Port Channel specified, the command clears all Port Channel counters.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Related
Commands
show lacp – displays the lacp configuration.
907