Dell Force10 Z9000 - Ecmp-Group

Usage
Information
This command applies to any physical interface with speed set to 10/100.
NOTE: Starting with FTOS version 7.8.1.0, when you use a copper SFP2 module with
catalog number GP-SFP2-1T in the S25P model of the S-Series, you can manually set its
speed with the speed command. When you set the speed to 10 or 100 Mbps, you can also
execute the duplex command.
Related
Commands
speed (for 10/100/1000 interfaces) – sets the speed on the Base-T Ethernet interface.
negotiation auto – enables or disables auto-negotiation on an interface.
ecmp-group
Provides a mechanism to monitor traffic distribution on a link aggregation group (LAG) bundle. A system log or simple
network management protocol (SNMP) trap is generated when the standard deviation of traffic distribution on a member
link exceeds a defined threshold.
S4810
Syntax
ecmp-group {ecmp-path} [interface interface] [monitoring
enable]
To negate a command, use the no command.
Parameters
ecmp-path Enter the path number for the LAG. The range is 2 to 64.
interface Enter the following keywords and slot/port to add the interface to the
LAG:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
monitoring Enter the keyword monitoring to monitor the LAG. To enable
monitoring, follow by entering the keyword
enable.
Defaults Off
Command Modes CONFIGURATION
Command History
Version 8.3.10.0 Introduced on the S4810.
695