Dell Force10 Z9000 - Neighbor Route-Map

Version 7.7.1.0 Introduced on the C-Series. Added 4-byte support.
Usage
Information
Applies to EBGP neighbors only.
You must configure your system to accept 4-byte formats before entering a 4-byte AS Number.
If the AS-PATH contains both public and private AS number or contains AS numbers of an
EBGP neighbor, the private AS numbers are not removed.
If a confederation contains private AS numbers in its AS-PATH, the software removes the
private AS numbers only if they follow the confederation numbers in the AS path.
Private AS numbers are 64512 to 65535 (2-byte).
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
neighbor {ip-address | peer-group-name} route-map map-name {in
| out}
To remove the route map, use the no neighbor {ip-address | peer-group-
name} route-map map-name {in | out} command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not configured, the default is deny (to drop all
routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of
the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in
the Route map used in this command. If you identify a peer by IP address, the Route map
overwrites either the inbound or outbound policies on that peer.
374