Dell Force10 Z9000 - Radius-Server Timeout; TACACS+ Commands; Debug Tacacs

radius-server timeout
Configure the amount of time the RADIUS client (the switch) waits for a RADIUS host server to reply to a request.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
radius-server timeout seconds
To return to the default value, use the no radius-server timeout command.
Parameters
seconds Enter the number of seconds between an unsuccessful attempt and
the FTOS times out. The range is zero (0) to 1000 seconds. The default
is 5 seconds.
Defaults 5 seconds
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Related
Commands
radius-server host – configures a RADIUS host.
TACACS+ Commands
FTOS supports TACACS+ as an alternate method for login authentication.
debug tacacs+
View TACACS+ transactions to assist with troubleshooting.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
debug tacacs+
To disable debugging of TACACS+, use the no debug tacacs+ command.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
1311