Dell Force10 Z9000 - Line

Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094).
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command
line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode, where you
can set the access conditions for the designated line.
C-Series, E-Series, S-Series, Z-Series
Syntax
line {aux 0 | console 0 | vty number [end-number]}
Parameters
aux 0 Enter the keyword aux 0 to configure the auxiliary terminal
connection.
NOTE: This option is supported on E-Series only.
console 0 Enter the keyword console 0 to configure the console port. The
console option for the S-Series is
<0-0>.
vty number Enter the keyword vty followed by a number from 0 to 9 to configure
a virtual terminal line for Telnet sessions. The system supports 10
Telnet sessions.
end-number (OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line
to configure. You can configure multiple lines at one time.
Defaults Not configured
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command
Usage
Information
You cannot delete a terminal connection.
121