Dell Force10 Z9000 - Route-Map

Related
Commands
match interface – redistributes routes that match the next-hop interface.
match ip address – redistributes routes that match an IP address.
match ip next-hop – redistributes routes that match the next-hop IP address.
match ip route-source – redistributes routes that match routes advertised by other routers.
match metric – redistributes routes that match a specific metric.
match route-type – redistributes routes that match a route type.
route-map
Enable a route map statement and configure its action and sequence number. This command also places you in ROUTE-
MAP mode.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
route-map map-name [permit | deny] [sequence-number]
To delete a route map, use the no route-map map-name [permit | deny]
[sequence-number] command.
Parameters
map-name Enter a text string of up to 140 characters to name the route map for
easy identification.
permit
(OPTIONAL) Enter the keyword permit to set the route map default
as permit. If you do not specify a keyword, the default is
permit.
deny (OPTIONAL) Enter the keyword deny to set the route map default as
deny.
sequence-
number
(OPTIONAL) Enter a number to identify the route map for editing and
sequencing with other route maps. You are prompted for a sequence
number if there are multiple instances of the route map. The range is
1 to 65535.
Defaults Not configured.
If you do not define a keyword (permit or deny) for the route map, the permit action is the
default.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names are up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
292