Dell Force10 Z9000 - Show Port-Channel-Flow

show port-channel-flow
Display an egress port in a given port-channel flow.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show port-channel-flow outgoing-port-channel number incoming-
interface interface {source-ip address destination-ip address}
| {protocol number | icmp | tcp | udp} | {source-port number
destination-port number} | {source-mac address destination-mac
address {vlan vlanid | ether-type}}
Parameters
outgoing-port-
channel number
Enter the keywords outgoing-port-channel followed by the
number of the port channel to display flow information.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number. For the C-Series, S-Series,
and Z-Series and S4810, the range is 1 to 128. For the E-
Series, the range is 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
incoming-
interface
interface
Enter the keywords incoming-interface followed by the
interface type and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
source-ip
address
Enter the keywords source-ip followed by the IP source address
in IP address format.
destination-ip
address
Enter the keywords destination-ip followed by the IP
destination address in IP address format.
protocol number |
icmp | tcp | udp
Enter the keyword protocol followed by one of the protocol type
keywords: tcp, udp, icmp, or protocol number.
NOTE: The protocol number keyword applies to E-Series only.
source-port
number
Enter the keywords source-port followed by the source port
number. The range is 1 to 65536. The default is None.
destination-port
number
Enter the keywords destination-port followed by the
destination port number. The range is 1 to 65536. The default is
None.
761