Dell Force10 Z9000 - Advertise Med Video-Signaling

priority-tagged
number
Enter the keywords priority-tagged followed the Layer 2
priority. The range is 0 to 7.
Defaults unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series and E-Series.
Related
Commands
debug lldp interface – debugs LLDP.
show lldp neighbors – displays the LLDP neighbors.
show running-config lldp – displays the LLDP running configuration.
advertise med video-signaling
Configure the system to advertise video control packets that use a separate network policy than video data.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
advertise med video-signaling {vlan-id layer2_priority
DSCP_value} | {priority-tagged number}
To return to the default, use the no advertise med video-signaling {vlan-id
layer2_priority DSCP_value
} | {priority-tagged number} command.
Parameters
vlan-id Enter the VLAN ID. The range is 1 to 4094.
layer2_priority Enter the Layer 2 priority (C-Series and E-Series only). The range is 0
to 7.
DSCP_value Enter the DSCP value (C-Series and E-Series only). The range is 0 to
63.
priority-tagged
number
Enter the keywords priority-tagged followed the Layer 2
priority. The range is 0 to 7.
Defaults unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
973