Dell Force10 Z9000 - Protocol Frrp; Show Frrp

Version 7.4.1.0 Introduced.
protocol frrp
Enter the Resilient Ring Protocol and designate a ring identification.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
protocol frrp {ring-id}
To exit the ring protocol, use the no protocol frrp {ring-id} command.
Parameters
ring-id Enter the ring identification number. Range: 1 to 255.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced
Usage
Information
This command places you into the resilient ring protocol. After executing this command, the
command line prompt changes to conf-frrp.
show frrp
Display the Resilient Ring Protocol configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show frrp [ring-id [summary]] | [summary]
Parameters
ring-id Enter the ring identification number. The range is 1 to 255
summary (OPTIONAL) Enter the keyword summary to view just a summarized
version of the Ring configuration.
Defaults none
Command Modes EXEC
645