• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For VLAN interface, enter the keyword vlan followed by a
number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
radius-server deadtime
Configure a time interval during which non-responsive RADIUS servers to authentication requests are skipped.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
radius-server deadtime seconds
To disable this function or return to the default value, use the no radius-server
deadtime command.
Parameters
seconds
Enter a number of seconds during which non-responsive RADIUS
servers are skipped. The range is 0 to 2147483647 seconds. The
default is 0 seconds.
Defaults 0 seconds
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
1307
To Next Page
Loading...
