Dell Force10 Z9000 - Capture Bgp-Pdu Neighbor; Capture Bgp-Pdu Max-Buffer-Size

capture bgp-pdu neighbor
Enable capture of an IPv4 BGP neighbor packet.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
capture bgp-pdu neighbor ipv4-address direction {both | rx |
tx}
To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-pdu
neighbor ipv4-address command.
Parameters
ipv4-address Enter the IPv4 address of the target BGP neighbor.
direction {both |
rx | tx}
Enter the keyword direction and a direction—either rx for
inbound, tx for outbound, or both.
Defaults Not configured.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.5.1.0 Introduced.
Related
Commands
capture bgp-pdu max-buffer-size – specifies a size for the capture buffer.
show capture bgp-pdu neighbor – displays BGP packet capture information.
capture bgp-pdu max-buffer-size
Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6 addresses.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
100-102400000 Enter a size for the capture buffer.
Defaults 40960000 bytes.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
347