Dell Force10 Z9000 - Enable Restricted

Use this parameter only with a password that you copied from the
show running-config file of another Dell Force10 router.
password Enter a text string, up to 32 characters long, as the clear text
password.
Defaults No password is configured. level = 15.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
Use this command to define a password for a level and use the privilege level
(CONFIGURATION mode) command to control access to command modes.
Passwords must meet the following criteria:
• Start with a letter, not a number.
• Passwords can have a regular expression as the password. To create a password with
a regular expression in it, you must use CNTL + v prior to entering regular expression.
For example, to create the password abcd]e, you type “abcd CNTL v ]e”. When
the password is created, you do not use the CNTL + v key combination and enter
“
abcd]e”.
NOTE: The question mark (?) and the tilde (~) are not supported characters.
Related
Commands
show running-config – views the current configuration.
privilege level (CONFIGURATION mode) – controls access to the command modes within the
switch.
enable restricted
Allows Dell Force10 technical support to access restricted commands.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
enable restricted [encryption-type] password
To disallow access to restricted commands, use the no enable restricted command.
Parameters
encryption-type
(OPTIONAL) Enter the number 7 as the encryption type.
Enter 7 followed a text string as the hidden password. The text string
must be a password that was already encrypted by a Dell Force10
router.
1297