Dell Force10 Z9000 - Advertise Dot3-Tlv

port-vlan-id Enter the keywords port-vlan-id to advertise the port VLAN
identification TLV.
vlan-name Enter the keywords vlan-name to advertise the vlan-name TLV.
This keyword is only supported on the C-Series and S-Series.
Defaults Disabled.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if- interface -lldp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series. Added the vlan-name option.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Related
Commands
protocol lldp (Configuration) – enables LLDP globally.
debug lldp interface – debugs LLDP.
show lldp neighbors – displays the LLDP neighbors.
show running-config lldp – displays the LLDP running configuration.
advertise dot3-tlv
Advertise dot3 TLVs (Type, Length, Value).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
advertise dot3-tlv {max-frame-size}
To remove advertised dot3-tlv, use the no advertise dot3-tlv {max-frame-
size} command.
Parameters
max-frame-size Enter the keywords max-frame-size to advertise the dot3
maximum frame size.
Defaults none
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if- interface -lldp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
956