Dell Force10 Z9000 - Flow-Based Enable

Parameters
description Enter a description regarding this session (80 characters maximum).
Defaults none
Command Modes MONITOR SESSION (conf-mon- sess-session-ID )
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-7.7.1.0 Introduced on the E-Series.
Related
Commands
monitor session – enables a monitoring session.
flow-based enable
Enable flow-based monitoring.
E-Series
Syntax
flow-based enable
To disable flow-based monitoring, use the no flow-based enable command.
Defaults Disabled, that is flow-based monitoring is not applied.
Command Modes MONITOR SESSION (conf-mon- sess-session-ID )
Command History
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
To monitor traffic with particular flows ingressing/egressing the interface, appropriate ACLs
can be applied in both ingress and egress direction.
Related
Commands
monitor session – enables a monitoring session.
1150