clear dampening
Clear the dampening counters on all the interfaces or just the specified interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
clear dampening [interface]
Parameters
interface
(OPTIONAL) Enter any of the following keywords and slot/port or
number to clear counters from a specified interface:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
Defaults Without an interface specified, the command clears all interface dampening counters.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
On the S4810, after you enter the clear counters command and verify the results with the
show interfaces command, the line rate is not reset to 0.00%.
Example
FTOS#clear dampening gigabitethernet 1/2
Clear dampening counters on Gi 1/2 [confirm] y
FTOS#
Related
Commands
show interfaces dampening – displays interface dampening information.
dampening – configures dampening on an interface.
689
To Next Page
Loading...
Need help?
General
