Dell Force10 Z9000 - Ip Ssh Pub-Key-File

Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
With password authentication enabled, you can authenticate using the local, RADIUS, or
TACACS+ password fallback order as configured.
ip ssh pub-key-file
Specify the file to be used for host-based authentication.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip ssh pub-key-file {WORD}
Parameters
WORD Enter the file name for the host-based authentication.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
This command specifies the file to be used for the host-based authentication. The creates/
file overwrites the flash://ADMIN_DIR/ssh/knownhosts file and deletes the user-
specified file. Even though this is a global configuration command, it does not appear in the
running configuration because this command needs to be run just once.
The file contains the OpenSSH-compatible public keys of the host for which host-based
authentication is allowed. An example known host file format:
poclab4,123.12.1.123 ssh-rsa AAAAB3NzaC1yc2EAAAABIwAAAIEAox/
QQp8xYhzOxn07yh4VGPAoUfgKoieTHO9G4sNV+ui
+DWEc3cgYAcU5Lai1MU2ODrzhCwyDNp05tKBU3t
ReG1o8AxLi6+S4hyEMqHzkzBFNVqHzpQc
+Rs4p2urzV0F4pRKnaXdHf3Lk4D460HZRhhVrxqeNxPDpEn WIMPJi0ds=
ashwani@poclab4
1329