redistribute isis
Redistribute IS-IS routes into BGP.
E-Series
Syntax
redistribute isis [level-1 | level-1-2 | level-2] [metric
metric-value | metric-type {external | internal}] [route-map
map-name]
To stop redistribution of IS-IS routes, use the no redistribute isis command.
Parameters
level-1 | level-1-2
| level-2]
(OPTIONAL) Enter the type (level) of routes to redistribute.
metric (OPTIONAL) Assign metric to an interface for use with IPv6
information.
metric-type (OPTIONAL) The external link type associated with the default route
advertised into a routing domain. You must specify one of the
following:
• external
• internal (default)
route-map
map-
name
(OPTIONAL) Enter the keywords route-map followed by the name
of an established route map. Only the following ROUTE-MAP mode
commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If you do not configure the route map, the default is deny (to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
498
To Next Page
Loading...
