Dell Force10 Z9000 - Logging Console; Logging Facility

logging console
Specify which messages are logged to the console.
C-Series, E-Series, S-Series, Z-Series
Syntax
logging console [level]
To return to the default values, use the default logging console command.
To disable logging to the console, use the no logging console command.
Parameters
level (OPTIONAL) Indicate a value from 0 to 7 or enter one of the following
parameters: emergencies, alerts, critical, errors,
warnings, notifications, informational, or
debugging. The default is 7 or debugging.
Defaults level = 7; size = debugging
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related
Commands
clear logging – clears the logging buffer.
default logging console – returns the logging console parameters to the default setting.
show logging – displays the logging setting and system messages in the internal buffer.
logging facility
Configure the Syslog facility used for error messages sent to Syslog servers.
C-Series, E-Series, S-Series, Z-Series
Syntax
logging facility [facility-type]
To return to the default values, use the no logging facility command.
Parameters
facility-type (OPTIONAL) Enter one of the following parameters:
• auth (authorization system)
• cron (Cron/at facility)
• deamon (system deamons)
• kern (kernel)
1384