Dell Force10 Z9000 - Power-On; Reload

Related
Commands
power-on – powers on a line card or standby SFM.
power-on
Turn on power to a line card or the standby (extra) SFM.
C-Series, E-Series
Syntax
power-on {linecard number | sfm sfm-slot-id}
Parameters
linecard number Enter the keyword linecard and a number for the line card slot
number. For the C-Series, the range is 0 to 7. For the E-Series, the
range is 0 to 13 on the E1200/E1200i, 0 to 6 on the E600/E600i, and 0 to
5 on the E300.
sfm standby Enter the keyword sfm followed by the slot number of the SFM to
power on.
NOTE: This option is supported on the E-Series only.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
Version 8.1.1.2 Introduced on the E-Series ExaScale E600i.
Version 8.1.1.0 Introduced on the E-Series ExaScale E1200i.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Related
Commands
power-off – powers off a line card or standby SFM.
reload
Reboot FTOS.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
reload [conditional nvram-cfg-change]
130