Dell Force10 Z9000 - Isis Metric

Version 7.5.1.0 Introduced on the E-Series.
Usage
Information
Dell Force10 recommends configuring metrics on all interfaces. Without configuring this
command, the IS-IS metrics are similar to hop-count metrics.
isis metric
Assign a metric to an interface.
E-Series, S4810
Syntax
isis metric default-metric [level-1 | level-2]
To return to the default values, use the no isis metric [default-metric]
[level-1 | level-2] command.
Parameters
default-metric Metric assigned to the link and used to calculate the cost from each
other router via the links in the network to other destinations. You can
configure this metric for Level 1 or Level 2 routing. The range is 0 to 63
for narrow and transition metric styles and 0 to 16777215 for wide
metric styles. The default is
10.
level-1 (OPTIONAL) Enter the keywords level-1 to configure the shortest
path first (SPF) calculation for Level 1 (intra-area) routing. This is the
default.
level-2 (OPTIONAL) Enter the keywords level-2 to configure the SPF
calculation for Level 2 (inter-area) routing.
Defaults default-metric = 10; level-1 (if not otherwise specified)
Command Modes INTERFACE
Command History
Version 8.3.12.0 Introduced on the S4810.
Usage
Information
Dell Force10 recommends configuring metrics on all interfaces. Without configuring this
command, the IS-IS metrics are similar to hop-count metrics.
879