Dell Force10 Z9000 - Radius-Server Retransmit

Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Authentication key length increased to 42 characters.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
The key configured on the switch must match the key configured on the RADIUS server
daemon.
If you configure the key parameter in the radius-server host command, the key
configured with the radius-server key command is the default key for all RADIUS
communications.
Related
Commands
radius-server host – configures a RADIUS host.
radius-server retransmit
Configure the number of times the switch attempts to connect with the configured RADIUS host server before declaring
the RADIUS host server unreachable.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
radius-server retransmit retries
To configure zero retransmit attempts, use the no radius-server retransmit
command.
To return to the default setting, use the radius-server retransmit 3 command.
Parameters
retries Enter a number of attempts that FTOS tries to locate a RADIUS server.
The range is zero (0) to 100. The default is 3 retries.
Defaults 3 retries
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Related
Commands
radius-server host – configures a RADIUS host.
1310