Dell Force10 Z9000 - Router Rip

To disable redistribution, use the no redistribute ospf process-id [match
external {1 | 2} | match internal | metric metric-value]
[route-map map-name] command.
Parameters
process-id Enter a number that corresponds to the OSPF process ID to be
redistributed. The range is 1 to 65355.
match external {1
| 2}
(OPTIONAL) Enter the keywords match external followed by the
numbers
1 or 2 to indicated that external 1 routes or external 2 routes
should be redistributed.
match internal (OPTIONAL) Enter the keywords match internal to indicate that
internal routes should be redistributed.
metric metric-
value
(OPTIONAL) Enter the keyword metric followed by a number as the
metric value. The range is 0 to 16.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name
of a configured route map.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
router rip
Enter ROUTER RIP mode to configure and enable RIP.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
router rip
To disable RIP, use the no router rip command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
1252