Dell Force10 Z9000 - Access-Class; Enable Password

access-class
Restrict incoming connections to a particular IP address in a defined IP access control list (ACL).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
access-class access-list-name
To delete a setting, use the no access-class command.
Parameters
access-list-name Enter the name of an established IP Standard ACL.
Defaults Not configured.
Command Modes LINE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Related
Commands
line – applies an authentication method list to the designated terminal lines.
ip access-list standard – names (or selects) a standard access list to filter based on the IP
address.
ip access-list extended – names (or selects) an extended access list based on the IP
addresses or protocols.
enable password
Change the password for the enable command.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
enable password [level level] [encryption-type] password
To delete a password, use the no enable password [encryption-type]
password [level level] command.
Parameters
level level (OPTIONAL) Enter the keyword level followed by a number as the
level of access. The range is 1 to 15.
encryption-type
(OPTIONAL) Enter the number 7 or 0 as the encryption type.
Enter a 7 followed by a text string as the hidden password. The text
string must be a password that was already encrypted by a Dell
Force10 router.
1296