Dell Force10 Z9000 - Bgp Always-Compare-Med; Bgp Asnotation

path-count Enter the number paths supported. The range is 2 to 64.
Defaults Disabled
Command Modes
• ROUTER BGP
• ROUTER BGP-address-family
Command History
Version 8.3.11.0 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Related
Commands
neighbor add-path – specifies that this neighbor/peer group can send/receive multiple path
advertisements.
bgp always-compare-med
Allows you to enable comparison of the MULTI_EXIT_DISC (MED) attributes in the paths from different external ASs.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
bgp always-compare-med
To disable comparison of MED, enter no bgp always-compare-med.
Defaults Disabled (that is, the software only compares MEDs from neighbors within the same AS).
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced command.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
Any update without a MED attribute is the least preferred route.
If you enable this command, use the clear ip bgp * command to recompute the best
path.
bgp asnotation
Allows you to implement a method for AS number representation in the command line interface (CLI).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
bgp asnotation [asplain | asdot+ | asdot]
To disable a dot or dot+ representation and return to ASPLAIN, enter the no bgp
asnotation
command.
Defaults asplain
332