Dell Force10 Z9000 - Show Dot1 X Interface

Command Modes
• EXEC
• EXEC privilege
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.4.2.1 Introduced on the C-Series and S-Series.
Usage
Information
Enter a supplicant’s MAC address using the mac-address option to display CoS mapping
information only for the specified supplicant.
You can display the CoS mapping information applied to traffic from authenticated supplicants
on 802.1X-enabled ports that are in Single-Hot, Multi-Host, and Multi-Supplicant authentication
modes.
Example
FTOS#show dot1x cos-mapping interface gigabitethernet 2/21
802.1p CoS re-map table on Gi 2/21:
----------------------------------
Dot1p Remapped Dot1p
0 7
1 6
2 5
3 4
4 3
5 2
6 1
7 0
FTOS#show dot1x cos-mapping int g 2/21 mac-address
00:00:01:00:07:00
802.1p CoS re-map table on Gi 2/21:
----------------------------------
802.1p CoS re-map table for Supplicant: 00:00:01:00:07:00
Dot1 Remapped Dot1p
0 7
1 6
2 5
3 4
4 3
5 2
6 1
7 0
show dot1x interface
Display the 802.1X configuration of an interface.
C-Series, E-Series, S-Series, S4810
Syntax
show dot1x interface interface [mac-address mac-address]
207