Dell Force10 Z9000 - Default-Information Originate

• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
NOTE: This option is available only on E-Series when entered as a
standalone option. It is available on both C-Series and E-Series as
a sub-option.
database (OPTIONAL) Enter the keyword database to display messages
when there is a change to the RIP database.
events (OPTIONAL) Enter the keyword events to debug only RIP protocol
changes.
packet (OPTIONAL) Enter the keyword events to debug only RIP protocol
packets.
NOTE: This option is available only on the C-Series.
trigger (OPTIONAL) Enter the keyword trigger to debug only RIP trigger
extensions.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
default-information originate
Generate a default route for the RIP traffic.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
default-information originate [always] [metric metric-value]
[route-map map-name]
To return to the default values, use the no default-information originate
command.
Parameters
always (OPTIONAL) Enter the keyword always to enable the switch
software to always advertise the default route.
1237