Dell Force10 Z9000 - Debug Lacp

debug lacp
Debug LACP (configuration, events, etc.)
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
debug lacp [config | events | pdu [in | out | [interface [in |
out]]]]
To disable LACP debugging, use the no debug lacp [config | events | pdu
[in | out | [interface [in | out]]]] command.
Parameters
config (OPTIONAL) Enter the keyword config to debug the LACP
configuration.
events (OPTIONAL) Enter the keyword events to debug the LACP event
information.
pdu in | out (OPTIONAL) Enter the keyword pdu to debug the LACP Protocol Data
Unit information. Optionally, enter an in or out parameter to:
• Receive enter in
• Transmit enter out
interface in | out (OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
Optionally, enter an in or out parameter:
• Receive enter in
• Transmit enter out
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
908