Dell Force10 Z9000 - Traceroute

traceroute
View a packet’s path to a specific device.
C-Series, E-Series, S-Series, Z-Series
Syntax
traceroute {host | vrf instance | ip-address | ipv6-address}
Parameters
host Enter the name of device.
vrf instance (Optional) E-Series Only: Enter the keyword vrf followed by the VRF
Instance name.
ip-address Enter the IP address of the device in dotted decimal format.
ipv6-address Enter the IPv6 address, in the x:x:x:x::x format, to which you are
testing connectivity.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
Defaults
• Timeout = 5 seconds
• Probe count = 3
• 30 hops max
• 40 byte packet size
• UDP port = 33434
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the E-Series ExaScale with IPv6.
Version 8.1.1.0 Introduced on the E-Series ExaScale (IPv4 only).
Version 7.9.1.0 Introduced VRF.
Version 7.6.1.0 Added support for the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Added support for IPv6 address on the E-Series.
E-Series Original command.
Usage
Information
When you enter the traceroute command without specifying an IP address (Extended
Traceroute), you are prompted for a target and source IP address, timeout (in seconds) (default
is
5), a probe count (default is 3), minimum TTL (default is 1), maximum TTL (default is 30), and
port number (default is 33434). To keep the default setting for those parameters, press the
ENTER key.
189