Related
Commands
show hardware layer2 acl – displays Layer 2 ACL data for the selected stack member and
stack member port-pipe.
show hardware layer3 – displays Layer 3 ACL or QoS data for the selected stack member and
stack member port-pipe.
show hardware stack-unit – displays the data plane or management plane input and output
statistics of the designated component of the designated stack member.
show hardware system-flow – displays Layer 3 ACL or QoS data for the selected stack member
and stack member port-pipe.
show interfaces stack-unit – displays information on all interfaces on a specific S-Series stack
member.
show processes memory (S-Series) – displays CPU usage information based on processes
running in an S-Series.
show processes ipc flow-control
Display the single window protocol queue (SWPQ) statistics.
C-Series, E-Series, S-Series, Z-Series
Syntax
show processes ipc flow-control [cp | rp1 | rp2 | lp linecard-
number]
Parameters
cp (OPTIONAL) Enter the keyword cp to view the control processor’s
SWPQ statistics.
rp1 (OPTIONAL) Enter the keyword rp1 to view the control processor’s
SWPQ statistics on Route Processor 1.
NOTE: Not supported in the S-Series.
rp2 (OPTIONAL) Enter the keyword rp2 to view the control processor’s
SWPQ statistics on Route Processor 2.
NOTE: Not supported in the S-Series.
lp
linecard-
number
(OPTIONAL) Enter the keyword lp followed by the line card number
to view the control processor’s SWPQ statistics on the specified line
card.
NOTE: Not supported in the S-Series.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
162
To Next Page
Loading...
