Dell Force10 Z9000 - Ip Ssh Hostbased-Authentication

Parameters
1-10 Enter the number of maximum number of incoming SSH connections
allowed per minute. The range is 1 to 10 per minute. The default is 10
per minute.
Defaults 10 per minute
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
ip ssh hostbased-authentication
Enable hostbased-authentication for the SSHv2 server.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip ssh hostbased-authentication enable
To disable hostbased-authentication for SSHv2 server, use the no ip ssh hostbased-
authentication enable
command.
Parameters
enable Enter the keyword enable to enable hostbased-authentication for
SSHv2 server.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
If you enable this command, clients can login without a password prompt. This provides two
levels of authentication:
• rhost-authentication is done with the file specified in the ip ssh rhostfile
command.
1327