Dell Force10 Z9000 - Monitor Session; Show Config

monitor session
Create a session for monitoring traffic with port monitoring.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
monitor session session-ID
To delete a session, use the no monitor session session-ID command.
To delete all monitor sessions, use the no monitor session all command.
Parameters
session-ID Enter a session identification number. The range is 0 to 65535.
Defaults none
Command Modes MONITOR SESSION (conf-mon- sess-session-ID )
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-7.7.1.0 Introduced on the E-Series.
Usage
Information
The monitor command is saved in the running configuration at Monitor Session mode level
and can be restored after a chassis reload.
Example
FTOS(conf)# monitor session 60
FTOS(conf-mon-sess-60)
Related
Command
show monitor session – displays the monitor session.
show running-config monitor session – displays the running configuration of a monitor session.
show config
Display the current monitor session configuration.
C-Series, E-Series, S-Series, Z-Series
Syntax
show config
Defaults none
Command Modes MONITOR SESSION (conf-mon- sess-session-ID )
1151