mask
Enter the mask of the IP address in the slash prefix length format (for
example, /24).
The mask appears in command outputs in dotted decimal format
(A.B.C.D).
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
Although FTOS does not generate a route due to the backdoor config, there is an option for
injecting/sourcing a local route in the presence of network backdoor config on a learned route.
redistribute
Redistribute routes into BGP.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static}
command.
Parameters
connected Enter the keyword connected to redistribute routes from physically
connected interfaces.
static
Enter the keyword static to redistribute manually configured
routes.
These routes are treated as incomplete routes.
route-map
map-
name
(OPTIONAL) Enter the keyword route-map followed by the name of
an established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all
routes).
382
To Next Page
Loading...
