Dell Force10 Z9000 - Debug Ip Bgp Keepalives; Debug Ip Bgp Notifications

Usage
Information
Enter the no debug ip bgp command to remove all configured debug commands for BGP.
debug ip bgp keepalives
Allows you to view information about BGP keepalive messages.
C-Series, E-Series
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name]
keepalives [in | out]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] keepalives [in | out] command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format followed by
the prefix length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group peer-
group-name
(OPTIONAL) Enter the keywords peer-group followed by the name
of the peer group.
in (OPTIONAL) Enter the keyword in to view only information on
inbound keepalive routes.
out (OPTIONAL) Enter the keyword out to view only information on
outbound keepalive routes.
Command Modes EXEC Privilege
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
Usage
Information
Enter the no debug ip bgp command to remove all configured debug commands for BGP.
debug ip bgp notifications
Allows you to view information about BGP notifications received from neighbors.
C-Series, E-Series
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name]
notifications [in | out]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] notifications [in | out] command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format followed by
the prefix length in the /x format. The range is /0 to /128.
474