Dell Force10 Z9000 - Show Memory (C-Series and E-Series)

Related
Commands
show linecard – view the line card status.
upgrade (E-Series version) – upgrades the boot flash, boot selector, or system image.
download alt-boot-image – downloads an alternate boot image to the chassis.
download alt-full-image – downloads an alternate FTOS image to the chassis.
download alt-system-image – downloads an alternate system image to the chassis.
show memory (C-Series and E-Series)
View current memory usage on the system.
C-Series, E-Series
Syntax
show memory [cp | lp slot-number | rp1 | rp2]
Parameters
cp (OPTIONAL) Enter the keyword cp to view information on the control
processor on the RPM.
lp slot-number (OPTIONAL) Enter the keyword lp and the slot number to view
information on the line-card processor in that slot. For the C-Series,
the range is 0 to 7. For the E-Series, The range is 0 to 13 on the E1200/
E1200i, 0 to 6 on the E600/E600i, and 0 to 5 on the E300..
rp1 (OPTIONAL) Enter the keyword rp1 to view information on Route
Processor 1 on the RPM.
NOTE: This option is supported on the E-Series only.
rp2 (OPTIONAL) Enter the keyword rp2 to view information on Route
Processor 2 on the RPM.
NOTE: This option is supported on the E-Series only.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
The output for show memory displays the memory usage of LP part (sysdlp) of the system.
The sysdlp is an aggregate task that handles all the tasks running on the C-Series’ and E-
Series' LP.
In FTOS Release 7.4.1.0 and higher, the total counter size (for all 3 CPUs) in show memory
(C-Series and E-Series) and show processes memory (C-Series and
E-Series)
differs based on which FTOS processes are counted.
154