Version 6.2.1.1 Introduced
Usage
Information
The connect-source option is used to supply a source IP address for the TCP connection.
When an interface is specified using the connect-source option, the primary configured
address on the interface is used.
If the total number of SA messages received from the peer is already larger than the limit when
this command is applied, those SA messages continue to be accepted. To enforce the limit in
such situation, use the clear ip msdp peer command to reset the peer.
Related
Commands
ip msdp sa-limit – configures the MSDP SA Limit.
clear ip msdp peer – clears the MSDP peer.
show ip msdp – displays the MSDP information.
ip msdp redistribute
Filter local PIM SA entries in the SA cache. SAs which are denied by the ACL will time out and not be refreshed. Until
they time out, they continue to reside in the MSDP SA cache.
E-Series, Z-Series, S4810
Syntax
ip msdp redistribute [list acl-name]
Parameters
list
acl-name
lEnter the name of an extended ACL that contains permitted SAs. If
you do not use this option, all local entries are blocked.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced
Usage
Information
Modifications to the ACL do not have an immediate affect on the sa-cache.
To apply the redistribute filter to entries already present in the SA cache, use the clear ip
msdp sa-cache local command.
984
To Next Page
Loading...
