Dell Force10 Z9000 - Ipv6 Flowlabel-Zero; Ipv6 Host

Default 100 pps
Command Modes CONFIGURATION
Command History
Version 8.3.12.0 Introduced on the S4810.
ipv6 flowlabel-zero
Configure system to set the flow label field in the packets to zero.
S4810
Syntax
ipv6 flowlabel-zero
To disable the 0 from being set in the field and allow the field to be filled by protocol operations,
use the no ipv6 flowlabel-zero command.
Default Disabled
Command Modes CONFIGURATION
Command History
Version 8.3.12.0 Introduced on the S4810.
Usage
Information
If the flowlabel value is already set for BGP or SSH, the system defaults to the already
configured value. All packets on the same connection are considered part of the same flow by
the system. For new connections, set the new flowlabel to zero.
ipv6 host
Assign a name and IPv6 address to be used by the host-to-IPv6 address mapping table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ipv6 host name ipv6-address
To remove an IP host, use the no ipv6 host name {ipv6–address}.
Parameters
name Enter a text string to associate with one IP address.
ipv6-address Enter the IPv6 address (X:X:X:X::X) to be mapped to the name.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0.0.0 Introduced on the Z9000.
839