Dell Force10 Z9000 - Show Cam Mac Linecard (Dynamic or Static)

Example
FTOS#show cam maccheck linecard 2 port-set 0
Dumping entries. From 0 to 16383.
Progress . marks 100 memory table entries.
..........Index 5576 (0x15c8) has valid entries (H: 2b9, E: 0)
<MAC_ADDR=0xffffffffffff,VLAN_ID=0xfff,PRI=0,CPU=0,DST_DISCARD=
0,
SRC_DISCARD=0,SCP
=0,TGID_LO=0,PORT_TGID=0,TGID_PORT=0,T=0,TGID_HI=0,
L2MC_PTR=0,MODULE_ID=0,REMOTE_T
RUNK=0,L3=0,MAC_BLOCK_INDEX=0,STATIC_BIT=1,RPE=0,
MIRROR=0,VALID=1,EVEN_PARITY=0,HI
TDA=0,HITSA=0>
..........Index 6592 (0x19c0) has valid entries (H: 338, E: 0)
<MAC_ADDR=0xa0000000,VLAN_ID=0xffe,PRI=0,CPU=0,DST_DISCARD=0,
SRC_DISCARD=0,SCP=0,T
GID_LO=0,PORT_TGID=0,TGID_PORT=0,T=0,TGID_HI=0,
L2MC_PTR=0,MODULE_ID=0x10,REMOTE_TR
UNK=0,L3=0,MAC_BLOCK_INDEX=0,STATIC_BIT=0,RPE=0,
MIRROR=0,VALID=1,EVEN_PARITY=1,HIT
DA=1,HITSA=1>
!-------------output truncated-------------------!
Example (Mac-
Address-Table)
FTOS#show mac-address-table
VlanId Mac Address Type Interface State
4094 00:00:a0:00:00:00 Dynamic Gi 2/0 Active
!-------------output truncated-------------------!
Example (Cam
Mac Linecard)
FTOS#show cam mac linecard 2 port-set 0
VlanId Mac Address Region Interface
0 ff:ff:ff:ff:ff:ff STATIC 00001
4094 00:00:a0:00:00:00 DYNAMIC Gi 2/0
!-------------output truncated-------------------!
l
show cam mac linecard (dynamic or static)
Display the CAM size and the portions allocated for MAC addresses and for MAC ACLs.
C-Series, E-Series, S4810
Syntax
show cam mac linecard slot port-set port-pipe [address mac_addr
| dynamic | interface interface | static | vlan vlan-id]
Parameters
linecard slot (REQUIRED) Enter the keyword linecard followed by a slot number
to select the linecard for which to gather information. For the C-
Series, the range is 0 to 4 (C150) and 0 to 8 (C300). For the E-Series,
the range is 0 to 6.
928