Dell Force10 Z9000 - Page 929

port-set port-pipe (REQUIRED) Enter the keywords port-set followed by a Port-Pipe
number to select the Port-Pipe for which to gather information. The
range is 0 or 1.
address mac-
addr
(OPTIONAL) Enter the keyword address followed by a MAC
address in the nn:nn:nn:nn:nn:nn format to display information on that
MAC address.
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC
addresses learned dynamically by the switch.
interface
interface
(OPTIONAL) Enter the keyword interface followed by the
interface type, slot and port information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series, the range
is 1 to 128. For the E-Series, the range is 1 to 255 for
TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/ port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
static (OPTIONAL) Enter the keyword static to display only those MAC
address specifically configured on the switch.
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to
display the MAC address assigned to the VLAN. The range is 1 to
4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Example
FTOS#show cam mac linecard 1 port-set 0
Port - (TableID) assignments:
00(01) 01(01) 02(01) 03(01) 04(01) 05(01) 06(01) 07(01) 08(01)
09(01) 10(01) 11(01)
12(01) 13(01) 14(01) 15(01) 16(01) 17(01) 18(01) 19(01) 20(01)
21(01) 22(01) 23(01)
Index Table ID VlanId Mac Address Region Interface
929