priority-cost
(OPTIONAL) Enter a number as the amount to be subtracted from the
priority value. The range is 1 to 254. The default is 10.
Defaults priority cost = 10
Command Modes VRRP
Command History
Version 7.6.1.0 Introduced on the S-Series (S50 only).
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
If the interface is disabled, the cost value is subtracted from the priority value and forces a
new MASTER election if the priority value is lower than the priority value in the BACKUP virtual
routers.
virtual-address
Configure up to 12 IP addresses of virtual routers in the VRRP group. You must set at least one virtual address for the
VRRP group to start sending VRRP packets.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
virtual-address ip-address1 [... ip-address12]
To delete one or more virtual IP addresses, use the no virtual-address ip-
address1
[... ip-address12] command.
Parameters
ip-address1
Enter an IP address of the virtual router in dotted decimal format. The
IP address must be on the same subnet as the interface’s primary IP
address.
... ip-address12
(OPTIONAL) Enter up to 11 additional IP addresses of virtual routers in
dotted decimal format. Separate the IP addresses with a space. The
IP addresses must be on the same subnet as the interface’s primary
IP address.
Defaults Not configured.
Command Modes VRRP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced support for telnetting to the VRRP group IP address
assigned using this command.
pre-Version
6.2.1.1
Introduced on the E-Series.
1481
To Next Page
Loading...
