Dell Force10 Z9000 - Set Local-Preference

stub-area Enter the keyword stub to redistributed matched routes to OSPF
stub areas.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
set automatic-tag – computes the tag value of the route.
set metric – specifies the metric value assigned to redistributed routes.
set metric-type – specifies the metric type assigned to redistributed routes.
set tag – specifies the tag assigned to redistributed routes.
set local-preference
Configure a filter to set the BGP LOCAL_PREF attribute for routers within the local autonomous system.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
set local-preference value
To delete a BGP LOCAL_PREF attribute, use the no set local-preference command.
Parameters
value Enter a number as the LOCAL_PREF attribute value. The range is 0 to
4294967295.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
297