Dell Force10 Z9000 - Ip Access-Group

Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increase the name string to accept up to 140 characters. Prior to
7.8.1.0, names were up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
ip access-group
Assign an IP access list (IP ACL) to an interface.
C-Series, E-Series, S-Series, Z-Series
Syntax
ip access-group access-list-name {in | out} [implicit-permit]
[vlan vlan-id]
To delete an IP access-group configuration, use the no ip access-group access-
list-name
{in | out} [implicit-permit] [vlan vlan-id] command.
Parameters
access-list-name Enter the name of a configured access list, up to 140 characters.
in Enter the keyword in to apply the ACL to incoming traffic.
out Enter the keyword out to apply the ACL to outgoing traffic.
NOTE: Available only on the 12-port 1-Gigabit Ethernet FLEX line
card. For specifications, refer to your line card documentation.
Not available on the S-Series.
implicit-permit (OPTIONAL) Enter the keyword implicit-permit to change the
default action of the ACL from implicit-deny to implicit-permit (that is,
if the traffic does not match the filters in the ACL, the traffic is
permitted instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the ID numbers of
the VLANs. The range is 1 to 4094 and 1 to 2094 for ExaScale (you can
use IDs 1 to 4094).
Defaults Not enabled.
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
215